Fitting Clear Side Repeaters.

	This Picture shows the correct orientation of the side repeater. On the right hand side of the light you will notice there is a flexible clip and on the left hand side two pegs. These hold the lens unit in place. To release the unit you need to slide it slightly to the right closing the flexible clip, at the same time levering the left hand side out past the pegs. This can be achieved using your fingers or a small screwdriver.

	Lift the lens away from the vehicle to reveal the wiring and connector plug.

	Release the plug and insert it into the new side repeater unit

	To re-fit the unit you simply slide the left hand side back into the hole making sure the two small pegs are caught behind the body panel, then applying slight pressure to the right hand side to close the flexible clip.

	Repeat this process for the opposite side and your done.