Range Rover Alarm - Ultrasonic Sensor Module
One of the most common failings with the Range Rover alarm system is the Ultrasonic Alarm Sensor Module.
For no apparent reason
these sensors just stop working, if you have 'ALARM FAULT' message
displayed on your dashboard we are confident this sensor is the cause.
As you can see from the
pictures, fitting a replacement is very easy and this process can be carried out in
under 60 seconds, no mechanical experience is necessary and no
tools are required.
The location of the sensor is in the interior roof
lining, just between the front & rear passenger doors as shown in
the 'upper image'. To release the sensor from the roof you simply grasp
it in your hand and lightly pull it away from the roof, then you unplug
the cable and plug it back into the new sensor. The sensor is then ready
to pushed back into the gap in the roof lining. You should now lock and then unlock the vehicle, start
the engine and that annoying 'ALARM FAULT' message should be gone.
